196VP

Medium Duty Variable Pressure Live Roller Accumulator Conveyor System

Specifications

Tread Rollers: 1.9" dia. x 16 ga. steel, model 196S.

Pressure Rollers: 1.9" dia. x 16 ga. steel, model 196S.

Return Rollers: 1.9" dia. x 16 ga. steel, model 196S, adjustable.

Belting: 2-1/4" wide "high strength" PVC-150 belt. *Note: when slave driving other units, optional 6" wide pvc-120 drive belt must be used on units 20' long and above.

Center Drive: Reversible drive with 24" integral belt take-up. For units under 8'-0" overall length, drive components must be stacked. Consult factory for minimum unit elevation.

End Pulley: 4" dia., crowned, with 1-3/16" dia. shaft.

Drive Pulley: *4" dia. with 1-3/16" dia. shaft or 8" dia. with 1-7/16" dia. shaft, both crowned and fully lagged.

Speed: 60 FPM, constant.

Bed: 7" x 1-1/2" x 12 ga. channel frame slotted for tread rollers to pop-out. When unit is installed at 7'-0" elevation or higher, rollers must be retained in conveyor frame. Specify desired elevation. Bed sections attached with couplings and floor supports.

Squaring Rods: Adjustable rods on underside of bed allow frame to be squared for improved belt tracking and are standard on all units over 30'.

Bearings: All pulley bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings.

Floor Supports: SM-6 adjustable 31-1/2" to 43-1/2" TOR. Supports should be lagged to floor.

Motor Drive: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.

Roller Chain: Drive pulley is driven by No. 50 roller chain for 1-1/2 HP or less and No. 60 chain on larger drives. Chain take-up provided on motor base.

Electrical Controls: Optional

24 Hour Shipments Include All 1-Foot Increments 6'- 0" TO 100'- 0"

Warning: Pop-out rollers should be retained in frame if unit is elevated to 7'-0" and above.

Back to Top