196LR

Medium Duty Belt Driven Live Roller Conveyor System

Specifications

Tread Rollers: 1.9" dia. x 16 ga. steel, model 196S.

Pressure Rollers: 1.9" dia. x 16 ga. steel, model 196S.

Belting: 6" wide black PVC-120 COS.

Center Drive: Reversible drive with 24" integral belt take-up. Specify location.

Drive Pulley: 4" dia. with 1-3/16" dia. shaft or 8" dia. with 1-7/16" dia. shaft, both crowned and fully lagged.

End Pulley: 4" dia., crowned, with 1-3/16" dia. shaft.

Return Rollers: 1.9" dia. x 16 ga. steel, model 196S, adjustable.

Bearings: All pulley bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings.

Speed: 60 FPM, constant.

Bed: 7" x 1-1/2" x 12 ga. channel frame slotted for tread rollers to pop-out. When unit is installed at 7'-0" elevation or higher, rollers must be retained in conveyor frame. Specify desired elevation. Bed sections attached with couplings and floor supports.

Squaring Rods: Adjustable rods on underside of bed allow frame to be squared for improved belt tracking and are standard on all units over 30'.

Floor Supports: SM-6 adjustable 31-1/2" to 43-1/2" TOR. Supports should be lagged to floor.

Motor Drive: 1/3 HP, 230/460/3,60 cycle, ODP right angle gear motor.

Roller Chain: Drive pulley is driven by No. 50 chain for 1-1/2 HP or less and No. 60 chain on larger drives. Chain take-up provided on motor base.

Electrical Controls: Optional

24 Hour Shipments Include All 1-Foot Increments 5'- 0" TO 100'- 0"

Warning: Prevent pinch points that exist when belt conveyors are permanently attached to other conveyors! Use connector brackets with safety pop out roller (other stationary equipment will require proper guarding and safety devices supplied by others).

Back to Top