196LRC

Medium Duty Belt Driven Live Roller Curve Conveyor System

Specifications

Tread Rollers: 2-1/2" dia. to 1-11/16" dia. x 14 ga. steel tapered rollers, model 254T; 1.9" dia. x 16 ga. steel straight tangent rollers, model 196S.

Pressure Sheaves: Provides drive belt pressure to upper tread rollers.

Belt: "B" section V-belt.

Take-Up: Screw type adjustable sheaves provided to maintain belt tension.

Tangents: 1'-0" both ends on 90°; 1'-6" both ends on 45°; 1'-0" both ends on 180°. Tangent roller centers provided on 3" RC.

Speed: 60 FPM, constant.

Bed: 7" x 1-1/2" x 12 ga. formed steel channel frame.

Bearings: End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings.

Floor Supports: SM-6 adjustable 31-1/2" to 43-1/2" TOR. Supports should be lagged to floor. Full support required at center of curves with 4'-0" inside radius.

Roller Chain: Drive shaft is driven by No. 50 chain.

Drive Location: Drive located on outside of curve. Specify left hand tangent length, right hand tangent length and drive location ("left hand drive" or "right hand drive"). Note: Drive hand determined with reference point located at outside of curve. For models slave driven (less drive), specify drive shaft location.

Capacity: 500 lb. total distributed live load.

Motor Drive: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor, located at infeed end of curve below bed on 45° and 90° curves; 3/4 HP supplied on all 180° curves.

Special Widths: Consult factory for pricing of ALL widths not shown.

Electrical Controls: Optional

24 Hour Shipments Include 45°, 90° And 180° Curves

Note: This unit is not recommended for accumulating loads.

Back to Top