196LRCS

Medium Duty Belt Driven Live Roller Curve Spur Conveyor System

Specifications

Tread Rollers: 2-1/2" dia. to 1-11/16" dia. x 14 ga. tapered rollers (model 254T); 1.9" dia. x 16 ga. (model 196S) straight tangent rollers.

Pressure Sheaves: Provides drive belt pressure to upper tread rollers.

Belt: "B" section V-belt.

Take-Up: Screw type adjustable sheave with flat idler sheaves provided to maintain belt tension.

Tangents: 12" opposite spur end on 60/30 unit; 18" opposite spur end on 45/45 unit.

Bed: 7" x 1-1/2" x 12 ga. formed steel channel frame.

Bearings: End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings.

Floor Supports: SM-6 adjustable 31-1/2"-43-1/2" TOR. Supports should be lagged to floor.

Motor Drive: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor, located at infeed end of curve below bed.

Spur Hand/Drive Location: Drive located on outside of curve. Specify hand of spur as "left hand" or "right hand" and location of drive specified as "left hand drive" or "right hand drive". NOTE: Drive location determined with reference point located at outside of curve. For models slave driven (less drive), specify drive shaft location.

Belt Speed: 60 FPM, constant.

Roller Chain: Drive shaft is driven by No. 50 chain.

Capacity: 500 lb. total distributed live load.

Electrical Controls: Optional

24 Hour Shipments Include 45/45° & 60/30° Curve Spurs

Note: This unit is not recommended for accumulating loads.

Back to Top