796LS

Line Shaft Driven Live Roller

Specifications

Tread Rollers: 1.9" dia. x 16 ga. steel, model 196S grooved.

Drive Belt: 3/16" dia., polyurethane belts. Nominal 15 lbs. per roller drive.

Drive Shaft: 1" dia. C1018 cold rolled steel shaft.

Couplings: Couplings located both ends (type "A"), one end only (type "B" or "C") or none (type "D"). See 'line shaft coupling chart' and specify.

Center Drive: Reversible drive; located approximately 18" from end of bed section for 3" and 6" RC; 16-1/2" for 4" RC.

Bearings: Precision, lubricated, ball bearing units with composite housings.

Speed: 60 FPM, constant.

Bed: 7" x 1-1/2" x 12 ga. formed steel channel frame. Bed sections attached with splice plates and floor supports.

Floor Supports: SM-6 adjustable 31-1/2" to 43-1/2" TOR. Supports should be lagged to floor.

Motor Drive: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.

Roller Chain: Drive shaft is driven by No. 50 chain. Chain take-up provided on motor base.

Capacity: See technical section for load capacity rating.

Electrical Controls: Optional.

24 Hour Shipments Include All 1-Foot Increments 2'- 0" TO 100'- 0"

Back to Top